Filter
Top Products
75
Adjustments and Settings for Recording : Viewfinder Screen Status Displays
Adjustments and Settings for Recording
In addition to video images, the viewfinder displays lamps and text that indicate the settings and operating status of the unit,
together with messages, a center marker, a safety zone marker and the camera ID.
The above viewfinder is the AJ-HVF21KG (for further
information on your optional viewfinder model, see the relevant
instruction manual).
1. TALLY/REC (recording) Lamp
This lamp stays illuminated during recording, and starts
blinking if any abnormal action occurs.
>[Warning System] (page 153)
2. Abnormal Operating Status Warning Lamp
This lamp comes on when the unit is in any of the
abnormal operating statuses specified through the
menu sub-option !LED.
>For statuses that activate the lamp, see the options in
the <!LED> screen in [!LED] (page 180).
3. BATT (battery) Lamp
This lamp starts blinking a few minutes before the
battery charge starts to run out, and stays illuminated
after the battery is completely flat. The battery should be
replaced before it is nearly flat, so that operation will not
be interrupted.
>[Warning System] (page 153)
4. SAVE Lamp
In the normal setting:
The lamp stays OFF.
When the menu option SAVE LED is set to “P2
CARD”:
The lamp starts blinking when the P2 card remaining
free space is getting low.
The menu item SAVE LED is found in the <VF
INDICATOR> screen on the VF page.
>[Warning System] (page 153)
The viewfinder can display a screen that allows you to check
the settings and status of the unit.
When you pull the MARKER SEL or MODE CHK/MENU
CANCEL switch of this unit toward you, 6 screen displays
switch.
STATUS screen > !LED screen > FUNCTION screen >
AUDIO screen > CAC screen > USER SW STATUS
screen > No indication
Each screen is displayed for about five seconds. When you
pull the MARKER SEL or MODE CHK/MENU CANCEL
switch toward you while displaying a screen, it moves to the
next screen.
Whether or not to display each screen is specified through
the <MODE CHECK IND> screen, which is accessible from
the VF page.
Viewfinder Screen Status Displays
Lamps in the Viewfinder Screen
1
2
3
4
Mode Check Screen Displays (MODE CHK function)
#
< MODE CHECK IND >
STATUS :ON
! LED :ON
FUNCTION :ON
AUDIO :ON
CAC :ON
USER SW STATUS :ON
P.ON IND :ON
AJ-HPX3100G(VQT3A79)_E.book 75 ページ ２０１０年９月１７日 金曜日 午後９時２１分