Filter
Top Products
44
Recording and Playback: Recording Review Function
When recording is paused, pressing the RET button
automatically locates the last two seconds of video just
recorded, and the viewfinder provides video playback.
After playback, the camera-recorder is again ready to start
recording.
The picture location/playback duration can be increased to
up to 10 seconds by continuously pressing the RET button.
For short clips, however, when the start of a clip is located,
continuously pressing the RET button does not play back
any clips before that clip.
The function of the RET button may be assigned to a
desired user button by using one of the menu options USER
MAIN SW, USER1 SW, USER2 SW, SHOT MARK (USER3)
SW or TEXT MEMO (USER4) SW. These options can be
found in the <USER SW> screen on the CAM OPERATION
page.
When recording is paused, pressing the PLAY/PAUSE
button plays back the last recorded clip, from the beginning.
This unit enters the recording standby mode after the
playback ends.
Notes
z Set the menu option RET SW to “R. REVIEW”. The menu item
RET SW is found in the <SW MODE> screen on the CAM
OPERATION page.
z When the SDI OUT MODE or MONITOR OUT MODE menu
option is set to “MEM”, the image of REC REVIEW is output
not only to the viewfinder but also on the video output
connector (SDI OUT connector, MON OUT connector) during
REC REVIEW.
Note that when a backup device is connected to back up the
video the pictures for REC REVIEW are backed up. These
menu items are found in the <OUTPUT SEL> screen on the
SYSTEM SETTING page.
z In ONE CLIP REC mode, the furthest rewind point using REC
REVIEW and the start point for playback after pausing a
recording is not at the start of the clip, but at the start of the
most recent recording.
Recording Review Function
Recorded clip
2-10 Seconds
The PLAY button plays back
the clip from the beginning.
Recording starts
Recording pauses
The RET button puts
the camera-recorder
into REC REVIEW
mode.
AJ-HPX3100G(VQT3A79)_E.book 44 ページ ２０１０年９月１７日 金曜日 午後９時２１分