Filter
Top Products
26
Parts and their Functions: Time Code Section
1. GENLOCK IN connector (BNC)
This connector is used to input a reference signal before
the camera unit is gen-locked, or before the time code is
externally locked.
> [Externally Locking the Time Code] (page 68)
2. SDI IN connector (BNC)
When GENLOCK is set on the camera, or when the time
code is externally locked, reference signals are input.
> [Externally Locking the Time Code] (page 68)
Note
Input SDI signal must be the same format selected on the
system mode menu of this unit.
3. TC IN connector (BNC)
This connector is used to input a reference time code
when you externally lock the time code.
> [Externally Locking the Time Code] (page 68)
4. TC OUT connector (BNC)
When you inter-lock the time code of camera-recorder
with that of an external device this must be connected
with the time code input (TC IN) connector of the
external device.
> [Externally Locking the Time Code] (page 68)
5. HOLD button
Pressing this button freezes the time data indication on
the counter. Note that time code generation continues.
Pressing the button again reactivates the counter.
This function is used to ascertain the time code or CTL
count of a particular recorded scene.
6. RESET button
This button resets the time data (CTL) on the counter to
“00:00:00:00”.
If this button is pressed when with the 8.TCG (time code
selector) switch positioned at [SET], time code and user
bits data are reset to 0, and real-time data is reset to the
initial value.
7. DISPLAY (counter display selector) switch
Indications of the time code, CTL and user bits on the
counter of the display window depend on the positions
of this switch and the 8.TCG (time code selector) switch.
Pressing the 5.HOLD button also displays Date/Time/
Time Zone.
UB: User bits/DATE/TIME/Time zone indicated.
TC: Time code indicated.
CTL: CTL indicated.
8. TCG (time code selector) switch
This switch is used to specify the stepping mode for the
built-in time code generator.
F-RUN: Select this position to continuously advance
the time code independently of the P2 card
recording status.
Use this mode to synchronise the time code
with the time of day, or to externally lock the
time code.
SET: Select this position to set the time code and/or
user bits.
R-RUN: Select this position to advance the time code
only during recording.
For spliced scenes recorded on P2 cards, the
sequence of time codes is unbroken.
9. CURSOR and SET buttons
Use these buttons to set the time code and user bits.
The four triangular buttons are the CURSOR buttons,
and the center rectangular one is the SET button.
> [Setting Time Data] (page 62)
Time Code Section
9
8
5
6
7
2 4 3
1
AJ-HPX3100G(VQT3A79)_E.book 26 ページ ２０１０年９月１７日 金曜日 午後９時２１分