Filter
Top Products
54
Adjustments and Settings for Recording : Setting the Electronic Shutter
The shutter speed in any shutter mode is set using the
SHUTTER switch.
In SYNCHRO SCAN mode, shutter speed can be switched
easily, using the SYNCHRO SCAN ADJUSTMENT switches
(+/–) on the side panel.
Note that the range of selectable shutter speeds may be pre-
defined; whether or not to use the SYNCHRO SCAN mode
may be determined through the <SHUTTER SPEED> and
<SHUTTER SELECT> screens.
>[CAM OPERATION] (page 181)
The selected shutter speed is retained even if the unit is
turned off.
1 Press the SHUTTER switch, positioned at
[ON], towards [SEL].
2 Once more, press the SHUTTER switch
towards [SEL]. Repeat this switchover until
the desired mode or speed appears in the
viewfinder screen.
If all modes and speeds are available, the display
changes in the following order:
See [Viewfinder Screen Status Displays] (page 75).
Note
SHUTTER mode turns off when operating the DS.GAIN.
Press the SHUTTER switch positioned at [ON] towards
[SEL], to place the camera-recorder in SYNCHRO SCAN
mode.
z In the SYNCHRO SCAN mode, it is possible to change the
shutter speed continuously by operating the SYNCHRO
SCAN (+/–) buttons.
z The shutter speed display in synchro scan mode is
switchable between second indication and angle
indication.
>[SYNCHRO SCAN DISP.] (page 177)
Setting the Shutter Mode and Speed
#
< SHUTTER SPEED >
SYNCHRO SCAN :ON
POSITION1 :ON
POSITION2 :ON
POSITION3 :ON
POSITION4 :ON
POSITION5 :ON
POSITION6 :ON
#
< SHUTTER SELECT >
POSITION1 SEL :1/100
POSITION2 SEL :1/120
POSITION3 SEL :1/250
POSITION4 SEL :1/500
POSITION5 SEL :1/1000
POSITION6 SEL :1/2000
Viewfinder displays relating to the shutter
SHUTTER switch
POSITION1 POSITION2 POSITION3 POSITION4 POSITION5 POSITION6
NORMAL mode
SYNCHRO
SCAN mode
Placing the Camera-recorder in SYNCHRO SCAN Mode
SHUTTER switch
SYNCHRO SCAN ADJUSTMENT buttons (+/–)
AJ-HPX3100G(VQT3A79)_E.book 54 ページ ２０１０年９月１７日 金曜日 午後９時２１分