Filter
Top Products
119
Manipulating Clips with Thumbnails: Thumbnail Manipulations Overview
Manipulating Clips with Thumbnails
Press the THUMBNAIL button to display the thumbnail
screen on the LCD monitor. Pressing the THUMBNAIL
button again returns the display to the regular display. When
switching is done from the regular screen display to the
thumbnail screen display, all the clips will be displayed on
the thumbnail screen.
Pressing the MENU button allows you to navigate the
thumbnail menu.
Note
When the TCG switch is set to [SET] to set the time code and
user bits or when the camera menu is open, the THUMBNAIL
button does not work.
1. Display Mode
The type of the thumbnail indicated on the display and
the types of the other information screens are indicated.
ALL: Display all clips.
SAME FORMAT:
Clips in the same format as the system format
(SYSTEM MODE item, REC FORMAT item,
AUDIO SMPL RES item) are shown.
>[Selecting a recording signal and method]
(page 47)
SELECT:The clips selected with the SET button are
shown.
MARKER
: Display clips with shot marks.
TEXT MEMO:
Display clips with text memo data.
SLOT n: Display clips in the specified P2 card.
(n: 1 or 2, which indicates Slots 1 or 2.)
UPDATING..:
Indicated when the camera-recorder is
updating the screen or reading data. When
the screen is being updated, the rotating icon
is indicated.
>[Switching the Thumbnail Display] (page 122)
2. Slot numbers and HDD status
This section indicates on which P2 card the pointed clip
is recorded. The number of the slot that contains the
appropriate P2 card is indicated in yellow. If the clip is
recorded on more than one P2 card, then the numbers
of all slots that contain the appropriate cards are
indicated. The numbers of the other slots are shown in
white if they contain P2 cards.
When the following P2 card is inserted, the slot number
is displayed with a pink frame.
z RUN DOWN CARD
(A P2 card on which the maximum number of
overwrites has been exceeded.)
z DIR ENTRY NG CARD
(A P2 card on which the directory structure is not
supported.)
The USB HDD section is indicated as follows:
z Other than the USB HOST mode: gray
z Not connected in USB HOST mode: gray
z HDD recognized and usable in USB HOST mode:
white
z HDD recognized and thumbnails shown in USB
HOST mode: yellow
z HDD recognized and not usable in USB HOST: red
3. Time Display
You can set this to display the time code at the start of
clip recording (TC), the user bits at the start of clip
recording (UB), the shooting time (TIME), the shooting
date (DATE), the shooting time date and time (DATE
TIME), or the user clip name (USER CLIP NAME).
4. Recording mode
The recording mode for the clip on which the pointer is
located is indicated.
5. System format
The format for the clip on which the pointer is located is
indicated.
6. Duration
The duration of the clip on which the pointer is located is
indicated.
7. USB HOST mode indicator
Indicated when the mode has been switched to USB
HOST.
Thumbnail Screen
11
8
9
10
12 13 14 15
4
5
6
7
1
2
3
16
Thumbnail screen
AJ-HPX3100G(VQT3A79)_E.book 119 ページ ２０１０年９月１７日 金曜日 午後９時２１分