Filter
Top Products
154
Maintenance and Inspections: Warning System
5. Image Sequence Error
Display window
indication
“E-40” appears in the time code display field.
WARNING lamp
Blinks 4 times per second.
Tally lamp
Blinks 4 times per second while recording
continues.
Viewfinder The REC WARNING indicator lights up.
Warning tone
Beeps 4 times per second.
Warning
description
There are abnormal conditions in the image
sequence of the 24P, 30P, or 25P mode.
Recording/
playback
operation
Images can be recorded and played back,
but some frames may be dropped or the
sequences of TC and UB may shift.
Countermeasures
Confirm the recording/playback operation
after turning OFF the power supply once and
then turning it on again. If the error is not
corrected after executing this procedure,
contact the dealer.
6. Corruption of Standard Signal
Display window
indication
“E-40” appears in the time code display field.
WARNING lamp
Blinks 4 times per second.
Tally lamp
Blinks 4 times per second.
Viewfinder
The TEMPORARY PAUSE indicator lights up.
Warning tone
Beeps 4 times per second while recording
continues.
Warning
description
Corruption in the input signals from the
standard GENLOCK IN and SDI IN
connectors means correct recording is not
possible, and this has stopped. The clip will
be divided.
Recording/
playback
operation
When the signal returns to normal, recording
will automatically start again. However, this
will not automatically start when in
INTERVAL REC mode or LOOP REC mode.
Countermeasures
Please check the input signal from the
GENLOCK IN connector or SDI IN connector.
If errors continue, please contact your dealer.
7. Recording Error
Display window
indication
“00:00:00:11” appears in the time code display
field. Even after recording is stopped, this
display continues to blink until the next
operation is performed.
WARNING lamp
Blinks 4 times per second while recording
continues.
Tally lamp
Blinks 4 times per second while recording
continues.
Viewfinder The REC WARNING indicator lights up.
Warning tone
Beeps 4 times per second while recording
continues.
Warning
description
This indicates a failure either in the P2 card
recording or the recording circuit.
Recording/
playback
operation
The recording may stop or continue.
Countermeasures
Restart recording. Or, turn the power OFF and
turn it ON again, before starting recording. If
the recording cannot be performed normally,
change the P2 card.
8. Number of Clips Exceeded
Display window
indication
“00:00:00:11” appears in the time code display
field. Even after recording is stopped, this
display continues to blink until the next
operation is performed.
WARNING lamp
Blinks 4 times per second while recording
continues.
Tally lamp
Blinks 4 times per second while recording
continues.
Viewfinder The OVER MAX# CLIPS indicator lights up.
Warning tone
Beeps 4 times per second while recording
continues.
Warning
description
This is displayed when attempting to record
clips where the total quantity exceeds the
upper limit (1000 pieces) for a single P2 card.
Recording/
playback
operation
Cannot record. Stops while recording.
Countermeasures
Insert a new P2 card or delete the unwanted
clips in the P2 card.
9. Low Wireless Signal Reception
Display window
indication
No display.
WARNING lamp
Blinks 4 times per second. (During pause and
recording)
Tally lamp
Blinks 4 times per second while recording
continues.
Viewfinder
The WIRELESS RF indicator lights up while
recording continues.
Warning tone
Beeps 4 times per second while recording
continues.
Warning
description
This error indicates poor wireless audio
reception conditions.
Recording/
playback
operation
Continues to operate without receiving the
wireless microphone signal.
Countermeasures
Check the microphone power supply and the
reception status of the wireless receiver.
10. Battery Nearly Empty
Display window
indication
One of the bars in the battery remaining
indicator starts blinking.
WARNING lamp
Blinks once per second.
Tally lamp Blinks once per second.
Viewfinder The BATT LED blinks.
Warning tone
Beeps 4 times per second.
Warning
description
The battery is about to run out.
Recording/
playback
operation
Continues to operate.
Countermeasures
Replace the battery as required.
AJ-HPX3100G(VQT3A79)_E.book 154 ページ ２０１０年９月１７日 金曜日 午後９時２１分