Filter
Top Products
86
Adjustments and Settings for Recording : Viewfinder Screen Status Displays
The center, safety zone, safety zone area and frame
markers may be set to ON or OFF, along with specifications
of the marker types. To set and select markers, go to the
<VF MARKER> screen from the VF page and select the
appropriate options.
>For directions on navigating the menu, see [Setting Menu
Options] (page 160).
Note
The indication MKR:A at the upper right of the screen shows
the current indication status. To view TABLE B, press the
MARKER SEL, MODE CHK / MENU CANCEL switch on the unit.
This changes the indication to MKR:B, allowing you to view the
set conditions.
The viewfinder can display a screen that allows you to view
the marker settings of the unit.
When you press the MARKER SEL, MODE CHK / MENU
CANCEL switch on the side of this unit, the marker
displayed by the viewfinder changes.
Marker A > Marker B > No marker
If the menu item FRAME SIG is set to 16:9 as the
information of Marker A and 4:3 as the information of Marker
B, then the 16:9 and 4:3 view angles can easily be checked
with the button, as required. The menu item FRAME SIG is
found in the <VF MARKER> screen on the VF page.
The viewfinder displays the return video signal input to the
GENLOCK IN or SDI IN connector while the RET button at
the lens is held down. To enable this function, select “CAM
RET” for the menu option RET SW.
In HD (1080i) mode, either the HD SDI signal from the SDI
IN connector, or the HD-Y signal from the GENLOCK IN
connector in the RETURN SIGNAL item can be selected. In
SD mode, only the SD SDI signal from the SDI IN connector
can be viewed.
The menu item RETURN SIGNAL is found in the
<GENLOCK> screen on the SYSTEM SETTING page, and
the menu item RET SW is found in the <SW MODE> screen
on the CAM OPERATION page.
Setting the Marker Displays
#
< VF MARKER >
MKR:A
TABLE :A
CENTER MARK :1
SAFETY MARK :2
SAFETY AREA :90%
FRAME MARK :OFF
FRAME SIG :4:3
FLAME LVL :15
Marker Check Screen Displays (MARKER SELECT button function)
MARKER SEL, MODE
CHK / MENU CANCEL
switch
Center marker
Markers
Safety zone
The view angle specified through the menu option
FRAME SIG is displayed.
Checking Return Video Signal in the Viewfinder
< SW MODE >
#
RET SW :R.REVIEW
S.BLK LVL :-10
AUTO KNEE SW :ON
SHD.ABB SW CTL :ON
COLOR BARS :SMPTE
S.GAIN OFF :L/M/H
DS.GAIN OFF :DS.GAIN
D.ZOOM
a
2 :ON
D.ZOOM
a
3 :ON
D.ZOOM
a
4 :ON
RC CHECK SW :R.REVIEW
AJ-HPX3100G(VQT3A79)_E.book 86 ページ ２０１０年９月１７日 金曜日 午後９時２１分