Filter
Top Products
142
Connection with external device: Connection using the SDI IN connector
1 Confirm that the connected device has the
same signal format as camera-recorder.
2 When signals are input from the SDI IN
connector, set the REC SIGNAL in the setting
menu to “SDI”.
The menu item REC SIGNAL is found in the <SYSTEM
MODE> screen on the SYSTEM SETTING page.
Notes
z When nothing is connected to the SDI IN connector or there
is no input signal, images to be recorded will be black and no
sound will be recorded. Input the same signals as the format
set in the SYSTEM MODE item in the setting menu through
the SDI IN connector. If the formats are different, data will not
be properly recorded on the P2 card. The menu item
SYSTEM MODE is found in the <SYSTEM MODE> screen on
the SYSTEM SETTING page.
z Note the following points when the REC SIGNAL of the
setting menu is set to “SDI”.
Audio signals are input from the SDI IN connector.
Audio signals must be input synchronized with video
images. Data will be recorded on the P2 card as 48 kHz/
4CH (16 bit or 24 bit). To record in 24 bit, the REC
FORMAT item must be set to AVC-I 100 or AVC-I 50, and
the AUDIO SMPL RES item to 24BIT. These menu items
are found in the <SYSTEM MODE> screen on the
SYSTEM SETTING page.
When the REC SIGNAL item is set to “SDI”, signals input
from the GENLOCK IN connector are disabled even if
nothing is connected to the SDI IN connector.
z UMID information, time code and user bits cannot be
recorded on a P2 card using the SDI IN connector.
Connection using the SDI IN connector
AJ-HPX3100G(VQT3A79)_E.book 142 ページ ２０１０年９月１７日 金曜日 午後９時２１分