Filter
Top Products
163
Flash Photography
3
Set the flash sync mode.
4
Set TTL-BL.
• Set the power switch of the Speedlight to ON and set the flash mode to
TTL auto flash.
5
Check the display in the LCD panel.
• Confirm that the indicator (SB-800) or (SB-600) for i-TTL
Balanced Fill-Flash appears in the LCD panel. If this indication does not
appear in the LCD panel, press the MODE button until it appears.
6
Compose picture, focus and confirm the indication in the viewfinder.
• Lightly press the shutter release button and confirm the in-focus / indicator
and ready-light indicator fi appears in the viewfinder.
7
Confirm the flash shooting distance range and shoot.
• If the ready-light blinks approx. 3 sec. after full flash output, underexposure
may have occurred. Check the focus distance, aperture or flash shooting
distance range and shoot again.
• When using a Speedlight, make sure to read its instruction manual as well.
CSM e1: Auto FP High-Speed Sync can be set, or 1/60 to 1/250 sec. can be
selected as the fastest limit for the sync shutter speed (x 104).
CSM e2: 30 to 1/60 sec. can be selected as the slowest limit for the sync
shutter speed in Programmed Auto or Aperture-Priority Auto (x 104).
P930_En 04.10.19 7:19 PM Page 163