Filter
Top Products
22
4. Loading Film and Setting Film Advance Mode
1
Turn the power switch on and lift the film
rewind knob. The camera back will pop
open.
2
Insert film and pull film leader out as far as
the red index mark.
• Film cartridge can be loaded smoothly if
inserted from the top.
• Make sure to insert the film cartridge all the
way in.
• Make sure to align the film leader to the red
index mark; if the film leader is not properly
aligned to the index mark (short of or beyond
the mark), film may not load properly.
• Hold the film cartridge down to ensure that the
film is properly positioned with no slack.
3
Press the film rewind knob down to its
original position and gently close camera
back until it locks. Film automatically
advances to the first frame.
• When 1 appears on the top LCD panel, the film
has advanced to the first frame.
• If Err and E blink in the top LCD panel and
viewfinder, and “FILM LOAD ERROR” is
displayed in the rear LCD panel, the film is not
properly installed. Open the camera back again
and reload film.
4
Set the film advance mode selector to S
(single-frame shooting) while pressing the
film advance mode selector lock release.
P930_En 04.10.19 7:18 PM Page 22