Filter
Top Products
46
Film—continued
•Film rewinding with button operation
To rewind film at mid-roll or when the Custom Setting Menu “d2:
Film rewind” (x 101) is set to “Manual”, rewind the film according
to the following instructions.
When rewinding film, make sure the film rewind knob is down.
• Film cannot be rewound with the film rewind knob in up position.
If film does not start to rewind or film
rewind stops at mid-roll
• When battery power is very low, or at low
temperatures, film may not start rewinding or film
rewind may stop at mid-roll, and o–– and the frame
number will blink in the top LCD panel and viewfinder.
In this case, turn the power switch off, change batteries, then turn the power switch
on and rewind film again. Or, rewind film manually using film rewind crank (x 47).
• When the power switch is turned off during film rewind, film rewind stops. In this
case, turn the power switch on and rewind film again. Or, activate film rewind
manually using the film rewind crank (x 47).
CSM d3: Film can be set to not rewind all the way and leave the film leader
out (x 101).
Open the R1 button cover and press the film
rewind R1 „ button then press the R2 „
button.
• o–– blinks in the top LCD panel and viewfinder
during film rewind and the frame counter counts
backwards until rewind is complete. Also,
“Rewinding...” is displayed in the rear LCD panel
during film rewind.
• Film is completely rewound when the frame counter
shows a blinking E in the top LCD panel and
viewfinder, and “REWIND COMPLETED” is displayed
in the rear LCD panel. (E appears without blinking
in the top LCD panel, and viewfinder indication and
“REWIND COMPLETED” disappear from the rear
LCD panel when the exposure meter is off.) Open
the camera back and remove the film cartridge.
P930_En 04.10.19 7:18 PM Page 46