Filter
Top Products
148 C626M-B (3/05)DX8000 PC Client Application
EXTERNAL MONITOR SETUP
EMERGENCY NOTIFICATION SETUP
The Emergency Agent Notification alerts selected clients of motion and alarm events detected by DX8000 server sites. When a motion or alarm
event is triggered, a pop-up window opens on the monitor of the remote site client. The window displays one or more still images taken during
the event.
Users with Power User access and higher can configure the emergency agent notification system. The first step in the setup process requires that
clients be added to the emergency agent notification list. To complete this step, you must provide a valid name and the IP address of each client
PC. After clients have been added they can be linked to one or more cameras. Finally, the amount of time a server sends images after an event
occurs and the interval between sending each image must be set.
ACCESSING THE EMERGENCY AGENT NOTIFICATION SETUP
To access the Emergency Agent Notification setup:
1. Click .
2. Click .
NOTE: The external monitor settings of a remote DVR cannot be changed from the DX8000 PC Client application. To change a DVR’s analog
monitor configuration, you must physically log in to a local DX8000 Series DVR as an Administrator or Power User. For more information on
configuring the DX8000’s optional analog monitor outputs, refer to the Operation and Programming manual that came with your unit.
IMPORTANT: Before configuring the Emergency Agent Notification, make sure the Emergency Agent Client utility is installed on one or
more client PCs. Refer to Installing the Client Emergency Agent Application on page 173.