Filter
Top Products
C626M-B (3/05) 173DX8000 Emergency Agent
DX8000 Client Emergency Agent
Setting Up and Using the Client Emergency Agent
DESCRIPTION
The DX8000 Client Emergency Agent works with networked DVRs to alert users when one or more particular channels detect a motion and/or
alarm event. The Emergency Agent runs on a networked client PC.
1. You must install the Client Emergency Agent software on your client PC before you can use it. Refer to the installation manual for
instructions on installing the Client Emergency Agent utility.
2. The DX8000 server must be turned on and operating.
3. Both the DX8000 server and client must be connected to the same network.
4. The Emergency Agent Notification system must be operating on the DX8000 server.
5. The client PC must be listed in the emergency agent notification list of the DX8000 server and at least one camera must be linked to the
client. Refer to Emergency Notifi
cation Setup on page 148 of this manual or the Operation and Programming manual for instructions.
6. The Client Emergency Agent must be configured and activated on the client PC.
INSTALLING THE CLIENT EMERGENCY AGENT APPLICATION
1. Start the Windows operating system.
2. Close all programs, including any antivirus software.
3. Insert the DX8000 Resource CD into the CD-ROM drive of your PC and wait for the DX8000 Resource CD screen to appear.
Figure 223. Resource CD Screen: Emergency Agent Installation Option
IMPORTANT: The following steps must be completed in sequence before the Emergency Agent can receive event notifications: