Filter
Top Products
Chapter 7 Menu Displays and Detailed Settings
123
7-3 Adjustments and Settings from Menus
3
Turn the MENU knob to move the b mark to “REAR
BNC OUT SEL”, and press the MENU knob.
The b mark on the left of “REAR BNC OUT SEL”
changes to a z mark and the z mark on the left of the
setting changes to a ? mark.
4
Turn the MENU knob to change the desired setting,
and press the MENU knob.
The z mark on the left of the selected item changes to
a b mark and the ? mark on the left of the setting
changes to a z mark.
5
To end the menu operation, set the MENU ON/OFF
switch to OFF or close the cover of the menu operating
section.
To enable DV stream output
Proceed as follows.
1
Holding down the MENU knob, move the MENU ON/
OFF switch to ON.
The TOP menu appears.
2
Turn the MENU knob to move the b mark to
“OPERATION”, then press the MENU knob.
If this is the first time the OPERATION menu has been
displayed, the CONTENTS page appears. If the menu
has been used before, the last accessed page appears.
3
If the CONTENTS page is displayed, turn the MENU
knob to move the b mark to POWER SAVE, then
press the MENU knob.
If a different page is displayed, turn the MENU knob
until the POWER SAVE page appears, then press the
MENU knob.
The POWER SAVE page appears. The current
settings appear on the right side of each item.
4
Move the b mark to “i.LINK OUT”, then press the
MENU knob.
The b mark changes to a z mark, and the z mark
changes to a ? mark.
5
Turn the MENU knob to select “ENABL”, then press
the MENU knob.
The setting is confirmed. The z mark changes to a b
mark and the ? mark changes to a z mark.
6
To end the menu operation, set the MENU ON/OFF
switch to OFF.
Notes
• As the i.LINK cable, use an S400-compliant cable
which is as short as possible (up to 1.5 m (5 feet)).
It may not be possible to establish a FAM
connection if a longer cable is used.
• DV streams are not output when the i.LINK DV IN/
OUT S400 connector is set to input.
Item Description
LCD BRIGHT <L> Adjusts the LCD brightness when the
LCD switch is in the L position.
LCD BRIGHT <H> Adjusts the LCD brightness when the
LCD switch is in the H position.
LCD COLOR Adjusts the color saturation of the LCD.
i.LINK SBP2
MODE
Selects whether or not to use the
i.LINK connector SBP2 interface.
REAR BNC OUT
SEL
Selects the type of the video signal to
be output from the VIDEO OUT
connector.
SDI : Outputs the SDI signal. When
SDI is selected, connect the
VIDEO OUT connector to the SDI
IN connector of the video monitor.
VBS: Outputs the analog composite
video signal. When VBS is
selected, connector the VIDEO
OUT connector to the VIDEO IN
connector of the video monitor.
This setting allows you to save the
power.
U01 OUTPUT
LCD BRIGHT <L> : 0
LCD BRIGHT <H> : 0
LCD COLOR : 0
PC REMOTE : DSABL
REAR BNC OUT SEL: VBS
TOP
Item Setting
i.LINK OUT Enable or disable i.LINK (AV/C) OUT.
REC AUDIO OUT Select whether to output E-E signals
or no audio from the AUDIO OUT
connector during recording.
NETWORK/
THUMB
Select whether to permanently enable
the CBK-NC01 (option) and thumbnail
display, or to disable them in power
saving mode.
04 POWER SAVE
i.LINK OUT : DSABL
REC AUDIO OUT : EE
NETWORK/THUMB : SAVE
TOP