Filter
Top Products
Chapter 5 Adjustments and Settings for Recording
89
5-6 Setting the Time Data
5-6 Setting the Time
Data
5-6-1 Setting the Time Code
The time code setting range is from 00 : 00 : 00 : 00 to 23
: 59 : 59 : 29 (hours : minutes : seconds : frames) for the
PDW-510/530, and from 00 : 00 : 00 : 00 to 23 : 59 : 59 :
24 for the PDW-510P/530P.
Note
When the scan mode is 24P (with the CBK-FC01
expansion board installed), the value of the least
significant digit is limited to 0 or 5.
To set the time code, proceed as follows.
Setting the time code
1
Set the DISPLAY switch to TC.
2
Set the PRESET/REGEN/CLOCK switch to PRESET.
3
Set the F-RUN/SET/R-RUN switch to SET.
The first (leftmost) digit of time code flashes.
4
Use the SEL/SET dial to set the time code value.
To change the value of the flashing digit, turn the dial,
and to shift to the next digit, press the dial. Repeat this
until all desired digits are set.
To reset the time code value to 00:00:00:00
Press the RESET button.
5
Set the F-RUN/SET/R-RUN switch to F-RUN or R-
RUN.
F-RUN: Free run. The time code generator keeps
running.
R-RUN: Recording run. The time code generator runs
only while recording.
To set the drop frame mode/non-drop frame
mode (only for the PDW-510/530)
You can select the drop frame (DF) mode or non-drop
frame (NDF) mode on the FUNCTION 1 page of the
USER menu or OPERATION menu or on the TIMECODE
page of the MAINTENANCE menu.
Note
When the scan mode is 24P (with the CBK-FC01
expansion board installed), NDF is selected automatically,
regardless of the menu setting.
To make the time code consecutive
When the F-RUN/SET/R-RUN switch is set to R-RUN,
recording a number of scenes on the disc normally
produces consecutive time code. However, once you
remove the disc and record on another disc, the time code
will no longer be contiguous when you use again the
original disc for recording. In this case, to make the time
code consecutive, proceed as follows.
1
Set the PRESET/REGEN/CLOCK switch to REGEN.
2
Press the RET button on the lens.
This reads the previous recording and synchronizes the
internal time code generator, thus allowing the new
time code recorded to follow on consecutively.
5-6-2 Saving the Actual Time in the
Time Code
Setting the PRESET/REGEN/CLOCK switch to CLOCK
saves the actual time in the time code.
When it is necessary to set the actual time, use the TIME/
DATE page of the DIAGNOSIS menu.
For details, see 7-3-6 “Setting the Date/Time of the
Internal Clock” on page 127.
5-6-3 Setting the User Bits
By setting the user bits (up to 8 hexadecimal digits), you
can record user information such as the date, time, or scene
number on the time code track.
To set the user bits, proceed as follows.
SEL/SET
THUMBNAIL
S.SEL
ESSENCE MARK
SUB CLIP
REGEN
CLOCK
F-RUN
SET
R-RUN
PRESET
SHIFTCLIP MENU
1
4
2
3
RESET
button