Filter
Top Products
3-6
Cisco NAC Guest Server Installation and Configuration Guide
OL-15986-01
Chapter 3 System Setup
Date and Time Settings
Figure 3-5 Date/Time Settings
Step 2 Select the correct Date and Time for the location of the Guest Server.
Step 3 Click the Set System Date and Time button to apply the time and date.
Step 4 Select the correct Timezone for the location of the Guest Server.
Step 5 Apply the settings by clicking the Set System Timezone button.
Note If you change the time zone, this action automatically adjusts the date and time on the server.
Step 6 If you have an NTP server available on the network, enter the address of the NTP server.
Step 7 Click the Set NTP Server button. This saves the settings and restarts the NTP process so the new settings
take effect.
Note When setting the NTP server it may take some time for synchronization to occur. Synchronization occurs
much faster if the time is set to be close to the NTP server (and saved with the Set button) before clicking
the Set NTP Server button.