Filter
Top Products
7-5
Cisco NAC Guest Server Installation and Configuration Guide
OL-15986-01
Chapter 7 Integrating with Cisco NAC Appliance
Configuring the CAM for Reporting
Note For detailed instructions on how to access and configure settings on the CAM, refer to the applicable
Cisco NAC Appliance - Clean Access Manager Installation and Configuration Guide.
Adding a RADIUS Accounting Server
Step 1 Log into the CAM web console as an admin user with an appropriate password (default
username/password is admin/cisco123).
Note Any CAM admin user with Edit privileges can perform this configuration.
Step 2 Navigate to User Management > Auth Servers > Accounting > Server Config
Figure 7-6 Configure RADIUS Accounting Server
Step 3 Click the checkbox for Enable RADIUS Accounting and configure the following fields:
• Server Name— Type the IP address of the Cisco NAC Guest Server
• Server Port —Type 1813 as the port
• Timeout (sec)—Type a timeout value; 10 seconds is typically sufficient.
• Shared Secret—Type the shared secret used with the Cisco NAC Guest Server. This must match the
shared secret configured on the Guest Server when adding the CAM as a RADIUS client to the Guest
Server, as described in
Adding RADIUS Clients, page 8-2. Make sure both shared secrets are the
same.
• NAS-IP-Address—Type the address of the CAM itself as the NAS-IP-Address.
Step 4 Click the Update button.