Filter
Top Products
Operating Instructions
1780R-Series Operator’s Manual
3–55
Left CRT display
Figure 3–26: Configure Menu Screen, page 3
Table 3–8: Configure Menu Selections, page 3
CW SYNC When CW subcarrier is used for vectorscope reference, wfm sync
source can be INT or EXT.
SLOW SWP TRIG Select positive or negative transition of the input signal to trigger slow
sweep.
BAUD RATE Select the baud rate for the serial interface.
VECT READOUT <ON> enables on-screen readouts of data during vectorscope
operation. <OFF> disables the readout. Full-screen menus are not
affected.
WFM READOUT <ON> enables on-screen readouts of data during waveform monitor
operation. <OFF> disables the readout. Full-screen menus are not
affected.
BEEP Beep is either on or off. When on, audio indicates when touch screen
selections have been made.
KNOB ASSIGN
TIMEOUT
When <ON>, with vectorscope CRT selected, will revert to waveform
CRT selection after 30 seconds of no knob activity.
VERSION The version of software currently installed.
Operating Instructions
1780R-Series Operator’s Manual
3–55
Left CRT display
Figure 3–26: Configure Menu Screen, page 3
Table 3–8: Configure Menu Selections, page 3
CW SYNC When CW subcarrier is used for vectorscope reference, wfm sync
source can be INT or EXT.
SLOW SWP TRIG Select positive or negative transition of the input signal to trigger slow
sweep.
BAUD RATE Select the baud rate for the serial interface.
VECT READOUT <ON> enables on-screen readouts of data during vectorscope
operation. <OFF> disables the readout. Full-screen menus are not
affected.
WFM READOUT <ON> enables on-screen readouts of data during waveform monitor
operation. <OFF> disables the readout. Full-screen menus are not
affected.
BEEP Beep is either on or off. When on, audio indicates when touch screen
selections have been made.
KNOB ASSIGN
TIMEOUT
When <ON>, with vectorscope CRT selected, will revert to waveform
CRT selection after 30 seconds of no knob activity.
VERSION The version of software currently installed.