Filter
Top Products
Operating Instructions
3–4
1780R-Series Operator’s Manual
Figure 3–1: Line Select Menu Screen with <2 OF 4> Fields selected
The waveform and vectorscope CRTs can be used to display the
same selected line or different lines. To display different lines,
enable the Line Select menu, then touch <WFM = VECT> until
<NO> is outlined. Be sure that both <VECT LSEL> and <WFM
LSEL> show <ON> outlined. Touch <LINESEL MENU> again, so
that <OFF> is outlined and the menu is no longer displayed on the
vectorscope CRT.
When different lines are displayed on waveform and vectorscope
CRTs, touch the line number area on the desired CRT to change the
large knob assignment. This assignment is indicated by a circle.
To display the same line on both CRTs, select <WFM = VECT> and
<YES>. The line number will be circled on both CRTs.
Operating Instructions
3–4
1780R-Series Operator’s Manual
Figure 3–1: Line Select Menu Screen with <2 OF 4> Fields selected
The waveform and vectorscope CRTs can be used to display the
same selected line or different lines. To display different lines,
enable the Line Select menu, then touch <WFM = VECT> until
<NO> is outlined. Be sure that both <VECT LSEL> and <WFM
LSEL> show <ON> outlined. Touch <LINESEL MENU> again, so
that <OFF> is outlined and the menu is no longer displayed on the
vectorscope CRT.
When different lines are displayed on waveform and vectorscope
CRTs, touch the line number area on the desired CRT to change the
large knob assignment. This assignment is indicated by a circle.
To display the same line on both CRTs, select <WFM = VECT> and
<YES>. The line number will be circled on both CRTs.