Filter
Top Products
Advanced Guide
Troubleshooting
Contents
>
Loading Paper
>
Loading Paper > Loading Paper in the Rear Tray > Loading Envelopes
C074
Loading Envelopes
You can print on European DL and US #10 envelopes.
The address is automatically rotated and printed according to the envelope's direction by specifying
with the printer driver properly.
Important
Do not use the following envelopes. They could jam in the printer or cause the printer to
malfunction.
- Envelopes with an embossed or treated surface
- Envelopes with a double flap (or sticker flaps)
- Envelopes whose gummed flaps are already moistened and adhesive
1. Prepare envelopes.
Press down on all four corners and edges of the envelopes to flatten them.
If the envelopes are curled, hold the opposite corners and gently twist them in the
opposite direction.
If the corner of the envelope flap is folded, flatten it.
Use a pen to press the leading edge in the inserting direction flat and sharpen the
crease.
The figures above show a side view of the leading edge of the envelope.
Important
The envelopes may jam in the printer if they are not flat or the edges are not aligned. Make
sure that no curl or puff exceeds 0.1 inches / 3 mm.
2. Load envelopes.
(1)
Open the Paper Support, and pull it out.
See (1) of step 2 in
Loading Photo Paper
.
(2)
Open the Paper Output Tray gently, and extend the Output Tray Extension to
open.
See (2) of step 2 in
Loading Photo Paper
.
(3)
Slide the Paper Guides (A) to open them, and load the envelopes in the center of
Page 33 of 468 pagesLoading Envelopes