Filter
Top Products
124
Setup Menu
Chapter 7 Menus
013 SYSTEM FREQUENCY
SELECT MENU
Specify whether to enable switching the system frequencies (59.94i, 59.94P,
29.97P, 50i, 50P, 25P, 23.98P).
off
: Do not enable switching the system frequencies.
on: Enable switching the system frequencies.
For details about switching the system frequencies, see page 43.
Note
Settings for both basic and extended menu items are saved separately for
different system frequencies.
• 1080 59.94i/29.97P
• 1080 50i/25P
• 1080 23.98P
• 720 59.94P
• 720 50P
Therefore, when you switch system frequencies, all menu items are reset to
the current settings for the new mode. (They are different from the setting for
the previous mode.)
016 ALARM DISPLAY Select whether to display alarm messages.
off: Do not display alarm messages. (However, certain important alarms are
displayed.)
limit (on (limited)): Display only a minimum number of alarm messages.
on
: Display all alarm messages.
For details about alarm message display conditions, see “Alarms”
(page 157).
017 SUB STATUS DISPLAY SELECT Determine the kind of sub status information to be output from the
COMPOSITE OUTPUT 2 (SUPER) connector, the SDSDI OUTPUT 2
(SUPER) connector, or the HDSDI OUTPUT 2 (SUPER) connector.
off
: Do not output sub status information.
rmain (disc remain): Available disc space (unit: minute)
clip (clip no): Order of playback of the selected clip/total number of clips
pbr (playback remain): The remaining playback time of the selected clip
from the current playback position (hours:minutes:seconds:frames).
edit (edit preset): Edit preset state
a)
ed&tc (edit preset & tc mode): Edit preset state and settings of timecode
a)
Note
When menu item 005 is set to “off”, sub status information is not displayed
when this item is set to anything other than “off”.
024 MENU CHARACTER TYPE Determine the type of characters in menu text output from the COMPOSITE
OUTPUT 2 (SUPER) connector, the SDSDI OUTPUT 2 (SUPER) connector,
or the HDSDI OUTPUT 2 (SUPER) connector for superimposed display on
the monitor.
white
: White letters on a black background.
black: Black letters on a white background.
W/out: White letters with black outline.
B/out: Black letters with white outline.
Set this item by selecting the required type while viewing the monitor.
028 HD CHARACTER Specify whether to superimpose text information on the video signal output
from the HDSDI OUTPUT 2 (SUPER) connector.
off: Do not superimpose.
f-key
: Follow the function menu setting.
029 STORED OWNERSHIP Specify whether to enable changing UMID ownership information settings
(COUNTRY, ORGANIZATION and USER).
off
: Do not enable.
on: Enable.
See “Using UMID Data” (page 171) for more information about UMID.
Item number Item name Settings