Filter
Top Products
147
Maintenance Menu
Chapter 7 Menus
M46: MENU
DATA
CONTROL
M461: MENU
STATUS
DISPLAY
Displays the status of the menu bank where the current menu settings are stored.
M462: SAVE
MENU DATA
Select whether to temporarily back up (save) setup menu settings before operations such as
software upgrades.
SAVE function button (F5): Back up (save) the settings.
MENU button: Return to next highest menu level without backing up.
M463: LOAD
MENU DATA
Select whether to restore (load) setting that were backed up (saved) with the “SAVE MENU
DATA” item.
SAVE function button (F5): Restore (load) the settings.
MENU button: Return to the next highest menu level without restoring.
M47: SETUP BANK4 Select the bank to be stored in menu bank 4, or reset menu bank 4.
CURRENT TO BANK4: Store the current menu settings in menu bank 4.
BANK1 TO BANK4: Store the menu bank 1 settings in menu bank 4.
BANK2 TO BANK4: Store the menu bank 2 settings in menu bank 4.
BANK3 TO BANK4: Store the menu bank 3 settings in menu bank 4.
RESET BANK4: Reset menu bank 4.
M48: AUTO RECALL Select whether to recall settings automatically from a menu bank when the system is
powered on, and if so which menu bank to recall from.
off
: Do not recall settings from a menu bank.
from BANK1: Recall settings from menu bank 1.
from BANK2: Recall settings from menu bank 2.
from BANK3: Recall settings from menu bank 3.
from BANK4: Recall settings from menu bank 4.
M49: RESET ALL SETUP Reset the current menu settings to the factory settings.
SAVE function button (F5): Reset.
MENU button: Return to the next highest menu level without resetting.
Notes
• The system frequency setting is also cleared. If you execute this item, reset the system
frequency (see page 33).
• Date and time settings are not cleared, but the time zone setting is cleared. After executing
this item, reset the time zone (see page 33).
M5: NETWORK: items relating to network settings
Item Setting
M50: DHCP Set whether to assign an IP address automatically with the DHCP server.
DISABLE
: Do not assign automatically.
ENABLE: Assign automatically.
M51: IP ADDRESS PRESET Set the IP address of this unit.
192.168.001.010
Notes
• IP address cannot be set when DHCP is set to “ENABLE”.
• To check the automatically acquired IP address of this unit, close the maintenance menu
and then open it again.
M52: SUBNET MASK PRESET Set the subnet mask.
255.255.255.000
Notes
• Subnet mask cannot be set when DHCP is set to “ENABLE”.
• To check the automatically acquired subnet mask, close the maintenance menu and then
open it again.
M4: SETUP MAINTENANCE: items relating to the setup menu
Item Setting