Filter
Top Products
132
Setup Menu
Chapter 7 Menus
317 [F1600]
AUDIO EDIT MODE
Select the type of audio transition used for linear editing.
cut edit: Cut editing (audio discontinuity at transition point, and possible
noise during playback).
cross fade
: Cross-fade
320 DIGITAL AUDIO PB PROCESS ON
EDIT POINT
Specify the handling of audio at edit points and at the second and
subsequent recording start points in Clip Continuous Rec recording.
cut: Carry out a cut (possibly resulting in audio discontinuities at the edit
point).
fade
: Fade out and fade in.
329 [F1600]
ANALOG AUDIO EDIT PRESET
REPLACE FOR CH5
Select methods for setting the edit presets of the digital audio channels
CH5 to CH8 of this unit. Make these settings when using an editor
(PVE-500, BVE-600, etc.) or remote control unit without a function to
control digital audio edit presets.
The edit presets of the digital audio channels of this unit are turned on
and off according to the specified analog audio presets of the editor or
remote control unit.
nodef (no definition)
: No definition
ch 1 (analog ch1): Follow the edit preset of analog channel 1.
ch 2 (analog ch2): Follow the edit preset of analog channel 2.
ch1+2 (analog ch1+ch2): Follow the edit preset of analog channel 1 or
2.
330 [F1600]
ANALOG AUDIO EDIT PRESET
REPLACE FOR CH6
331 [F1600]
ANALOG AUDIO EDIT PRESET
REPLACE FOR CH7
332 [F1600]
ANALOG AUDIO EDIT PRESET
REPLACE FOR CH8
344 ASSEMBLE AUTO EDIT
POSTROLL RECORDING
Set whether to record 2 seconds of postroll when an additional clip is
recorded by sending the AUTO EDIT command (9-pin protocol 20·42)
from a nonlinear editing system connected to the REMOTE(9P)
connector on the rear panel.
Note
When using a linear editing system, postroll will not be recorded
regardless of this setting.
off: Do not record postroll.
on
: Records approximately 2 seconds of postroll.
Menu items in the 300s, relating to editing operations
Item number Item name Settings
Menu items in the 400s, relating to preroll
Item number Item name Settings
401 FUNCTION MODE AFTER CUE-UP Select the state that the unit goes into after a cuing-up operation.
stop
: Stops (the stop mode).
still: Still playback (in jog and shuttle mode).
Menu items in the 500s, relating to disc protection
Item number Item name Settings
501 STILL TIMER To protect the disc against shock and vibrations, and to lengthen the life
of the laser diodes, the unit automatically enters standby off mode
whenever a specified time elapses in a disc stop mode (stop mode or the
still picture mode of search mode). This allows you to set the time after
which the unit exits a disc stop mode and enters standby off mode.
0.5 s (0.5 sec)... 8 m (8 min)
... 30 m (30 min): Can be set in the range
from 0.5 seconds to 30 minutes.
off: Do not put into standby off mode.