Filter
Top Products
97
Transferring clips (Direct FTP function)
Chapter 5 Operations in GUI Screens
Transferring clips (Direct FTP function)
You can transfer clips (MXF files) between this unit and
external devices over a network. This unit has an Direct
FTP function, which allows you to connect to any
XDCAM device or computer with an FTP server function
and transfer files with a few simple operations in the GUI
screen.
The following table lists the types of file transfers that this
unit can execute.
File transfers with this function are limited to clips (high-
resolution data) and clip list files. To transfer files of other
types (proxy AV data, files in the General and User Data
directories, and so on), operate after establishing a FAM or
FTP connection (see page 104).
Preparations for clip transfers
Check the following points.
• This unit must be connected over a network to the
transfer target device (XDCAM device or computer).
• The settings under maintenance menu item M5:
NETWORK must be set to values that allow network
connections.
• The remote control switch must be set to NET.
• For XDCAM devices that support UPnP (universal plug
and play), the UPnP function must be enabled (the
setting may vary).
To enable the UPnP function
The UPnP (universal plug and play) function allows
devices to be easily connected to networks. The following
XDCAM devices support UPnP.
• PDW-F1600
• PDW-HD1500
•PDW-F800
Transfer direction Transfer target Function
Upload One or more clips put
Multiple clips with clip list
Part of one clip partial put
Download One clip get
Note
Transfer direction Transfer target Function
Upload clip (put)
Download clip (get)
a) The following software requirements must be satisfied.
• An FTP server function must be available.
• In the case of Windows, Microsoft Window IIS (Internet Information
Service) Version 7.0 or higher.
• In the case of Macintosh, Mac OS X Version 10.5.6 or higher.
Network
Local host (this unit)
PDW-HD1500
Laptop computer
a)
Material server
Remote server