Filter
Top Products
52
Handling Discs
Chapter 3 Preparations
Handling Discs
Discs used for recording and
playback
This unit can record and play back the following
Professional Disc
1)
formats.
• PFD23A (capacity 23.3 GB)
• PFD50DLA (capacity 50.0 GB)
1) Professional Disc is a trademark of Sony Corporation.
• It is not possible to use the following discs for recording
or playback:
- Blu-ray Disc
- Professional Disc for Data
• PFD50DLA discs can be used only by XDCAM devices
with the DL mark (see the following illustration). They
cannot be used by XDCAM devices without this mark.
Notes on handling
Handling
The Professional Disc is housed in a cartridge, and is
designed to allow handling free of risk from dust or
fingerprints. However, if the cartridge is subjected to a
severe shock, for example by dropping it, this can result in
damage or scratching of the disc. If the disc is scratched, it
may be impossible to record video/audio, or to play back
the content recorded on the disc. The discs should be
handled and stored carefully.
• Do not touch the surface of the disc itself within the
cartridge.
• Deliberately opening the shutter may cause damage.
• Do not disassemble the cartridge.
• The supplied adhesive labels are recommended for
indexing discs. Apply the label in the correct position.
Storage
• Do not store discs where they may be subjected to direct
sunlight, or in other places where the temperature or
humidity is high.
• Do not leave cartridges where dust may get inside.
• Store cartridges in their cases.
Care of the discs
• Remove dust and dirt on the outside of a cartridge using
a soft dry cloth.
F4: PC RMT Enables or disables a FAM connection.
The connection can be cut off while it is
maintained or remade while it is
disabled.
ENABLE: Enable a connection.
DISABLE
: Disable a connection.
Notes
• PC REMOTE under maintenance
menu item M33: FILE I/F CONFIG
must be set to “F-KEY SELECT” in
order to use this function (see
page 144).
• “DISABLE” is always selected when
the unit is powered off and then on
again, regardless of the previous
setting.
F5: (Unassigned function button)
F6: (Unassigned function button)
Item Setting
Notes
DL mark