Filter
Top Products
33
Initial Setup
Chapter 3 Preparations
3
Slide the BP-GL95 as shown below so that the
connectors on the BP-GL95 and the BKP-L551 are
connected.
4
Connect the DC cable of the BKP-L551 to the DC IN
12V connector.
Removing the battery pack
With the lever pushed in, slide the BP-GL95 out as shown
below.
Checking the remaining battery power
You can use the LEDs on the side panel of the battery to
check the remaining power of the battery.
Initial Setup
This unit is shipped with the area of use, system frequency,
recording format, and current date and time still unset.
Therefore, you need to make initial setup settings before
using the unit. (You cannot use the unit without setting it
up.)
Once the unit has been set up, the settings are retained even
when the unit is powered off.
Use the following procedures.
1
Power the unit on.
The INITIAL SETUP screen appears on the display.
2
Turn the PUSH SET(S.SEL) knob to select the area of
use.
Display UC (for regions outside Japan) or J (for
Japan), and then press the SET function button (F5).
The system frequency screen appears.
3
Turn the PUSH SET(S.SEL) knob to select the system
frequency.
BP-GL95
Lever
REC
NET
REMOTE
LOCAL
VARIABLE KEY INHI
PRE-
SET
ON
OFF
PB
PHONES LEVEL
SHIFT
DISPLAY
HOME
PAG E
EXPAND
CHAPTER
TOP F REV F FWD END STANDBY REC INHI
PREV NEXTPLAY STOP REC
THUMBNAIL
RETURN
PUSH SET(S.SEL)
MENU
RESET
MARK2
MARK1
IN OUT
SHTL/JOG
SUB CLIP
DISC MENU
VAR/JOG
EJECT
ACCESS
CH-1
ALL CH
CH-2
CH-3
CH-4
POWER
AC IN
1
55,6 2,3,4
RETURN
SET
INIT
INITIAL SETUP
UC/J MODEL
SELECT
NONE
INC/DEC : CTRL.KNOB
CANCEL&PREV : F1(RET)
SET&NEXT : F5(SET)