Filter
Top Products
165
Troubleshooting
Appendix
Alarms relating to audio and video signals
a) Displayed only when setup menu item 016 ALARM DISPLAY is set to
“on”.
Alarms relating to sensors and drives
Not Loaded. This appears when a command related to planning metadata is executed with no planning
metadata loaded.
Load planning metadata and try again.
Syntax Error! This appears when loading of planning metadata fails because of a syntax error. Correct the
syntax error and try loading the metadata again.
Irregular Disc is Used.
Use Professional Disc.
This appears when the unit is unable to record or play the inserted disc.
This unit can record and play Professional Discs. Insert a Professional Disc.
The Disc Write Protect TAB
is set to Save.
This appears when an attempt is made to format a write-protected disc.
Try formatting the disc after moving the write protect tab away from the Save position.
The REC Inhibit Mode is
Selected.
Check Function Menu.
This appears when an attempt was made to format when function menu item HOME >F3: REC
INH is set to “ON”.
Set F3: REC INH to “OFF” and try formatting again.
Auto Formatting was not
Completed.
This appears when auto formatting fails.
Video Resolution Differ from
it on Clip List.
This appears when an attempt is made to add a clip to a clip list containing clips with a different
video resolution (number of system lines).
It is not possible to add clips to clip lists containing clips with a different video resolution.
No Clip Meets the Condition. This appears when no clip is found to meet clip filtering conditions.
Alarm message in time
data display area
Alarm message in video monitor screen Action
No INPUT!
a)
INPUT VIDEO IS NOT DETECTED.
CHECK THE VIDEO INPUT MODE AND
SUPPLY A VIDEO SIGNAL TO VIDEO
INPUT.
• Check the setting of V INPUT on Page P1 VIDEO of
the function menu (see page 49).
• Input an HDSDI signal.
EMPHASIS!
a)
INPUT AUDIO EMPHASIS IS NOT
SUPPORTED.
CHECK THE EMPHASIS OF THE AUDIO
INPUT SIGNAL.
Check the emphasis of the audio input signal.
REF NON-STD A NON-STANDARD REF SIGNAL IS
BEING USED FOR REF VIDEO. USE A
STANDARD SIGNAL.
Input a standard signal.
Alarm message in GUI
screen
Description/action
Alarm message in time
data display area
Alarm message in video monitor acreen Description/action
FAN Stopped FAN MOTOR STOPPED. Contact a Sony service representative.
Note
The unit will not stop operating, but if you continue to
use it in this state temperatures inside the unit or the
drive will rise, possibly resulting in failure or fire.
DR-FAN Stop DRIVE FAN MOTOR STOPPED.
N-FAN Stop FAN MOTOR ON NET-4 BOARD
STOPPED.
High TEMP! HIGH TEMPERATURE.
HIGH TEMPERATURE IN DRIVE.
HIGH TEMPERATURE ON NET-4 BOARD.
HUMID! MOISTURE HAS BEEN DETECTED. Stop recording or playback, power the unit off and on
again, and wait until the HUMID display disappears.
BATT EMPTY! BATTERY EMPTY! Change the battery.