Filter
Top Products
1.
Load the film into the Film Guide correctly, with the front side of the film (the side on
which images appear correctly) facing down.
The long sides of the film are curled up.
2.
With the glossy side (the side without illustrations) facing up, insert the Film Retainer
Sheet (A) under the edge of the film.
3.
Close the Film Holder (B) and secure it into the Film Guide.
The entire film is pressed flat with the Film Holder.
Note
If Newton's rings still appear after scanning with the above method, the film is heavily warped.
Try the following method.
1. Turn over the film and load it into the Film Guide, with the front side of the film (the side on
which images appear correctly) facing up.
The long sides of the film are curled down.
2. With the rough side (illustrated side) facing up, place the Film Retainer Sheet (A) on the
edge of the film.
3. Close the Film Holder and secure it into the Film Guide.
4. After preview, click
(Mirror) on the Toolbar of ScanGear (scanner driver) to invert the
images, then click Scan.
Page top
Page 26 of 334 pagesPlacing Film