Filter
Top Products
System Set-Up 43
VIS-CAM System
• Press the “Repetitive Trigger” button on the ENSetup toolbar. This will trigger the camera every
second. Make sure that the “Ethernet” external hardware trigger is enabled in the “Camera
Properties” section “2 – Trigger”, property “External Trigger Source”.
• Adjust the flash head tilt and pan control until the entire back of the vehicle is well illuminated.
If necessary, adjust the flash-head pan control to center the flash beam over the vehicle.
• If the flash illumination is too bright for your installation, contact JAI for instructions on how to
adapt VIS system parameters to reduce sensitivity to nighttime illumination.
Repeat pressing the “Repetitive Trigger” button on the ENSetup toolbar to stop flash firing. Repeat
the above steps for each camera/flash.
Table 13 Optimal Illumination Distance Between Camera and TNF
Distance in Feet
TS-9720EN
TSC-9720EN
TS-2030EN
TSC-2030EN
TS-2076EN
TSC-2076EN TS-1327EN
TSC-1327EN
3.5 TBD 2
1
TBD
TBD
TBD TBD
Distance measured from outer wall of Camera housing to outer wall of Flash unit.