Filter
Top Products
Appendix E: Moxa N Port 5232 Configuration 87
VIS-CAM System
9 Appendix E: Moxa N-Port 5232 Configuration
Configuration of the Moxa N-Port server is done through a standard web-browser or using Telnet.
If you are unfamiliar with the configuration terms, please consult the enclosed Moxa N-Port server
manual.
To carry out the configuration using Internet Explorer, type the IP-address of the unit in the address
field:
http://192.168.127.254 <CR>
You should now be able to configure the unit through the embedded web-server.
To carry out the configuration using Telnet, open the command prompt window – type the following:
Telnet 192.168.127.254 <CR>
You should now be able to configure the unit through the Telnet interface.
The necessary settings will be listed under its designated sub-menu. The items underlined in bold
italics (example - Delimiter: D
) must be configured as described.
Basic Settings:
Server name: Enter the desired name for the N-Port server.
Time zone: Enter the correct time zone for the system location.
Local time: Enter the correct time for the system location.
Time server: Enter IP-Address or domain name for the desired time server.
Web console: Enables / Disables the web configuration utility.
Telnet console: Enables / Disables the Telnet configuration utility.
Figure 87. Standard configuration of Basic Settings: