Filter
Top Products
113
This section enables you to assign an IP address to each camera
and configure various auto detect settings.
Specifying IP Lease
For configuring the function to assign IP addresses to each network
camera.
Note :
●
In order to assign an IP address of the network camera using the
IP Lease feature, you need to enable the DHCP of the network
camera. For procedures to enable the DHCP of the network
camera, refer to the instruction manual of the network camera.
1 Select [Auto Detect Setting] from [Main Menu]
●
The [Auto Detect Settings] screen appears.
2 Select [Enable] in [IP Lease]
Memo :
●
If a network uses a multiple number of NVR units, enable the [IP
Lease] only for one unit. Select [Disable] if a DHCP server is
operating on the same network.
●
When the [IP Lease] is enabled for two or more devices at the
same time, the IP address may change to a static address, and
cause malfunction of the cameras.
3 Specify the following items under [IP Lease
Parameter]
4 Click [OK]
●
Doing so hides the setting screen and starts IP Lease.
●
Select
A
Disable
B
in Step
2
to stop IP Lease.
Auto Detect Settings
2
3
4
[Auto Detect Settings] Screen
Item Description
Start Address For specifying the first IP address to be
assigned to the cameras.
Unit For selecting the number of IP addresses
to be assigned to the cameras. The
selected number of IP addresses will be
assigned starting from the first IP address.
Subnet Mask For specifying the subnet mask for the
cameras.
Default Gateway For specifying the gateway for the
cameras.
DNS Server For specifying the DNS server address for
the camera(s).
Domain Name For specifying the domain name for the
cameras.
Lease Time Limit For specifying the valid period of the IP
address assigned to the cameras. If
A
Ye s
B
is selected, you can set the lease time in
units of hours.
Client For selecting whether to apply restrictions
on the device when assigning the IP
address. If
A
Only Camera
B
is selected, IP
address will only be assigned to the
corresponding camera. If
A
Any Client
B
is
selected, IP address will be assigned to all
devices.
Reserve MAC
Address
Configure the [Reserve MAC Address] if
you want to assign a specific IP address to
the cameras. A specific IP address is
always mapped to a MAC address. Enter a
value in the MAC and IP fields, and click
[Add] to set the addresses. To cancel the
setting, select a displayed MAC and IP
address, and click [Del].