Filter
Top Products
120
Applications
Master/Slave Settings
This section enables you to add/delete NVR units as the
slave server.
To use an NVR unit as the master server, you need to select
the [Designate as Master Server] check box and register
slave servers using the steps below.
Ⅵ Adding Slave Servers
1 Select [Slaves] in the [Master/Slave Setup]
section
2 Select [Add Slave] on the [Slave Administration]
screen
3 Select [Hostname]/[Port] on the [Add New Slave]
screen
4 Click the [OK] button to register the specified
NVR unit as a slave server
Note :
● Up to four slave servers can be registered for one NVR
unit (master).
● A total of 80 cameras can be managed by one master/
slave system.
● The version of all NVR units in a master/slave system
must be set the same.
● The NVR unit operating as a master server cannot be
used as a slave server for another NVR unit.
● When operating as a master server, the recording display
performance may drop.
Memo :
● VR-N1600U/E and VR-N900U may be mixed in a master/
slave system.
Distribution Settings
(Details) (continued)
1
2
3