Filter
Top Products
75
ⅷ Other Settings
Item Preset Values Description
B Day and Time Properties
To synchronize the time with the Internet time server or to specify the date and
time manually, click [Update Now].
Automatically
synchronize with an
Internet server
Select check box
● Do not select
check box
Select this check box to synchronize the time with the Internet time server.
Note :
●
You cannot specify the date and time manually when this box is selected. The
settings in the boxes cannot be changed.
●
The date and time properties are not enabled until you have clicked the
[Update Now] button.
●
Changing the time setting may prevent normal playback of recordings made at
the same time as a result.
●
Changing the
A
Time
B
field of the time setting when operations are in progress
may prevent normal display of live images. In this case, reboot this unit.
Server
^
Enter the address of the Internet time server.
Note :
●
Connect the time server to the LAN2 network.
NTP Polling Interval
^
For specifying the time interval (in minutes) for synchronizing with the Internet
time server.
Date
^
Enter this field when you are specifying the date manually.
Memo :
●
The [Day and Time Properties] settings are not enabled until you have clicked
the [Update Now] button.
●
Changing the time setting may prevent normal playback of recordings made at
the same time as a result.
●
Changing the
A
hour
B
value of the hour/minute/second setting when operations
are in progress may prevent normal display of the live images. In this case,
reboot this unit.
Time
Time Zone ● VR-1600U:
(GMT-05:00)
Eastern Time
● VR-1600E:
(GMT) Greenwich
Mean Time
For specifying the time zone.
Note :
●
Make sure that the date and time that you specify does not overlap with any
previous recorded data.
●
If the specified time zone is incorrect, the system may not run at the correct
time after synchronizing with the Internet time server.
●
When the time zone is altered, press the [LIVE/BROWSE] while holding down
the [FUNCTION] button to reboot the NVR Viewer.
C Volume Properties
Device Volume
● Center position
Adjust the volume using the slider bar.
D LOAD configuration
^
Reads the preset configuration files and displays them on the screen.
E SAVE changes
^
Exits after entries and the selected content are configured to the system.
Manual update of time is disabled. To update the time manually, go to the [Day
and Time Properties] item
C
.
F CANCEL changes
^
Exits without saving all entries and selected settings.