Filter
Top Products
57
Item Preset Values Description
ERecording Settings (continued)
Enable speedup
On motion
On event
Enables you to specify whether to execute recording with a higher maximum frame rate when
motion is detected or when an event occurs.
When [On event] is selected : Specify the starting and ending events in the [Start]
and [Stop] fields respectively.
The speedup recording frame rate uses the [Frame
Rate] in the [Speedup Settings] A item.
When the input is analog : Values of frame rate that can be set are 30, 15, 10, 7,
6, 5, 3, 2, and 1.
When set to 7, the rate is 7.5 frames per second.
When to store
images in
database
Always
Never
ⅷ Conditionally
Always : Select this check box to record images at all times.
Never : Do not perform recording in the recording control mode. Record
starts when the [REC/STOP] button is pressed.
Enables you to specify the recording conditions in recording control mode. If you have
selected [Conditionally], specify the following fields as well.
On motion : Select this check box to record all images for which motion has been
detected.
On event : Select this check box to record all images from the occurrence of an
event until the next event occurs regardless of motion. Specify the
starting and ending events in the [Start] and [Stop] fields
respectively.
Memo :
●
For details on events, refer to [Camera Input/Output Port and Events] (
A
Page 95).
Note :
●
If you have selected [Conditionally], the [ALARM] indicator on the front panel lights up
regardless of the recording status when the motion or event specified in [When to store
images in database] occurs. Press the [ALARM CLEAR] button to turn off the light of the
[ALARM] indicator.
( )seconds pre/post recordings on motion/event:
You can record images preceding and following a detected motion or event. Specify the time
interval to record in the number of seconds before and after the occurrence. (
A
Page 139)
Memo :
●
Do not set to
A
0 seconds
B
.
●
If Offline is selected in [Scheduler...], images will not be recorded.
●
This setting has no impact on manual recording, emergency recording, and [EXT REC IN]
recording.
F Datebase
Settings
^
Enables you to specify the database settings. (
A
Page 110)
G Motion
Detection
Settings
^
Motion Detection.. Enables you to specify the two parameters for motion detection, namely [Sensitivity] and
[Motion Sensitivity]. (
A
Page 104)
Motion Color.. Enables you to specify the color to be used for highlighting detected motion.