- 194 -
Book Copying
Use this feature to copy a book. If the book is too thick, lift the scanner lid until its hinges are
engaged by the stopper and then close the scanner lid. If the book or magazine is thicker
than 30 mm (1.18 inches), start copying with the scanner lid open.
This special copy mode can be applied when you load a document using only the
document glass. If a document is detected in the DADF, the book copying feature does not
work.
1
Place a single document face down on the glass as below :
2
Press
Copy
Layout
Book
from the home screen.
OR
Press
All Applicatons
()
Book Copy
from the home screen.
3
Press the left/right arrows to select you want.
•
Both
: Prints both facing pages of the book.
•
Left
: Prints left page of the book.
•
Right
: Prints right page of the book.
4
Press
Start
( ) on screen to begin copying.
NOTE: You can cancel the copy job at any time. Press ( ) on screen, and
the copying will stop.