Filter
Top Products
- 222 -
Re-connecting to a network
When the wireless function is on, the machine automatically tries to re-connect to the
access point (or wireless router) with the previously used wireless connection settings and
address. If not successful after two minutes, the wireless connection will be stopped and
Wi-Fi setting is turned off.
NOTE: In the following cases, the machine automatically re-connects to the
wireless network:
• The machine is turned off and on again.
• The access point (or wireless router) is turned off and on again.
• The light blinks fast on the WPS LED. The machine tries connecting to the access
point (or wireless router).
Disconnecting from a network
There are two methods available to disconnect the wireless network.
a
Press
(WPS) button
(on the control panel) less than 2 seconds
Wi-Fi
Activate
(from the home screen)
Off
.
b
Press
My Settings
Machine Setup
Network Setup
Wi-Fi
Wi-Fi
Activate
Off
from the home screen.
Using the menu button
Before starting, you will need to know the network name (SSID) of your wireless network
and the Network Password if it is encrypted. This information was set when the access point
(or wireless router) was installed. If you do not know about your wireless environment,
please ask the person who set up your network.
NOTE: After completing the wireless network connection, you need to install a
machine driver to print from an application. See "
Installing driver over the network".
1
Press
My Settings
Machine Setup
Network Setup
Wi-Fi
Wi-Fi Activate
On
and select
Wi-Fi Settings
from the home screen .
2
select the setup method you want.
•
Search List
(recommended): In this mode, the setup is automatic. The machine
will display a list of available networks to choose. From after a network is chosen
then printer will prompt for the corresponding security key.
•
Custom
: In this mode, users can give or manually edit their own SSID , or choose
the security option in detail.
Using other menu buttons
•
Wi-Fi
: You can turn the
Wi-Fi
on/off.
•
Wi-Fi Direct
: You can turn the
Wi-Fi Direct
on/off.
•
WPS
:You can select Connecting method.
•
Wi-Fi Signal
: You can check the Wi-Fi status.
•
Wi-Fi Default
: Sets default.