Filter
Top Products
251
Troubleshooting / Guide de dépannage
Symptom Cause and/or Corrective Actions
• The input selector on the VCR is not set correctly.
c Set the selector correctly, then check the connection between
the VCR and your camcorder (p. 103).
• Your camcorder is connected to the DV equipment of other
than Sony using the i.LINK cable.
c Set it to IR (p. 104).
• Setting a programme on a blank portion of the tape is
attempted.
c Set the programme again on a recorded portion (p. 110).
• The synchronization of your camcorder and the VCR is not
adjusted.
c Adjust the synchronization of the VCR (p. 107).
• The IR SETUP code is not correct.
c Set the correct code (p. 106).
• Setting a programme on a blank portion of the tape is
attempted.
c Set the programme again on a recorded portion (p. 165).
• COMMANDER in is set to OFF in the menu settings.
c Set it to ON (p. 233).
• Something is blocking the infrared rays.
c Remove the obstacle.
• The batteries are inserted in the battery holder with the + –
polarities incorrectly matching the + – marks.
c Insert the batteries with the correct polarity (p. 299).
• The batteries are dead.
c Insert new ones (p. 299).
• DISPLAY is set to V-OUT/LCD in in the menu settings.
c Set it to LCD (p. 233).
• Moisture condensation has occurred.
c Remove the cassette and leave your camcorder for at least
one hour to acclimatize (p. 279).
• Some troubles have occurred in your camcorder.
c Remove the cassette and insert it again, then operate your
camcorder.
c Disconnect the AC Adaptor from a wall socket or remove the
battery pack, then reconnect it in about one minute. Turn the
power on. If the functions still do not work, press the RESET
button using a sharp-pointed object. (If you press the RESET
button, all the settings including the date and time return to
the default) (p. 24, 26, 293).
Digital program editing on the tape
does not function.
Digital program editing on the
“Memory Stick” does not function.
The Remote Commander supplied
with your camcorder does not work.
The picture from a TV or VCR does
not appear even when your
camcorder is connected to the
outputs on the TV or VCR.
The melody or beep sounds for
five seconds.
No function works though the power
is on.
Types of trouble and how to correct trouble
(continued on the following page)