Filter
Top Products
UBCD396XT
89
26. Tone Out mode
With the tone out feature, the scanner monitors up to 10 different channels for paging
tones (two-tone sequential, single tone, and group tone). Normally, the scanner
monitors each of the 10 channels in turn. However, if any tone-out channels share the
same frequency, modulator, and attenuator settings, the scanner checks these channels
simultaneously.
Configuring Tone Out channels
To configure Tone-Out channels:
1. Go to the Tone-Out for... menu.
2. Select Tone-Out Setup.
3. Select the Tone-Out channel (Tone-Out 1 through Tone-Out 10 ) you want to
configure.
4. Select Set Frequencies and choose the frequencies for this channel
5. Select Set Tone and program Tone A and Tone B.
6. Set any of the other properties as you prefer (they aren't required).
Required
Frequencies ( Set Frequencies)
Tone A and Tone B ( Set Tones)
Recommended
Name ( Edit Name)
Optional
Automatic Gain Control ( Set Audio AGC)
Delay Time ( Set Delay Time)
Alert ( Set Alert)
Using Tone-Out Mode
To start a Tone-Out search:
1. Tap MENU.
2. Scroll down and select Tone-Out for...
3. Select Tone-Out Standby to start the search.
The scanner starts searching the most recently-used Tone-Out channel (and any
other Tone-Out Channels that have the same frequency).
If you want to search a different channel, just turn the SELECT-VOLUME-
SCROLL knob until you find the channel you want.