Filter
Top Products
UBCD396XT
126
37. Scan mode
Scanning vs. Searching
Scan and Search mode have very similar operations. In both Scan and Search
modes, the scanner steps through a set of frequencies and checks for activity. For
Scan mode, you program each individual frequency or Talk Group ID you want the
scanner to check; for Search mode, you designate a range of frequencies and the
scanner will check each individual frequency that falls within that range.
With trunked systems, Scan mode and Search mode are very similar, so the
scanner can combine the two in a single operation, switching from one to the other
depending on the settings of each individual system:
Scanning trunked systems
The scanner scans a system if the ID Scan Search option is set to ID Scan
The scanner only checks for activity on unlocked Talk Group IDs that are
programmed for this system.
If any programmed Talk Group ID becomes active, the scanner switches to
the voice channel and monitors the transmission until it ends or until the
Delay Time expires.
The scanner checks each unlocked Talk Group ID at least once; if the hold
time has expired, it moves on to the next system.
Searching trunked systems
The scanner searches a system if the ID Scan Search option is set to ID
Search.
When any Talk Group ID becomes active, the scanner checks to see if that
ID is locked out.
If the ID is unlocked, the scanner switches to the voice channel and monitors
the transmission until it ends or until the Delay Time expires.
The scanner monitors the system until the hold time expires, then moves on
to the next system.
Default Scan Mode
In the default Scan mode, the scanner checks frequencies in the following order: