Filter
Top Products
UBCD396XT
109
Select the number of milliseconds (after the start of a transmission) the scanner
should wait while checking for P25 data. Choose a number from 0 through 1000
ms in 100 ms increments. The scanner only applies the wait time setting to
Conventional or Motorola (non P25) systems, and only when the channel's Audio
Mode setting is All.
Trunked system options
The following options are available when you're editing a trunked system:
ID Scan/Search
Choose whether the scanner only checks the Talk Group IDs that you program ( ID
Scan ) or checks all the Talk Group IDs it can find ( ID Search ) when scanning
this site.
Priority ID Scan
Choose On to have the scanner check any priority-labeled channels in this system
during Priority ID Scan mode. Choose Off if you want the scanner to ignore this
system when scanning priority channels.
Emergency Alert
This menu lets you configure whether the scanner triggers an alert tone and light
when it detects an emergency flag within an active Talk Group. (Compare this to
the channel setting Set Alert, which can trigger an alert tone and light whenever a
channel becomes active.) The settings for Set Alert Tone and Set Alert Light are
common to both types of alerts.
Set ID Format (DEC/HEX) or (AFS/DEC)
Trunked systems have three different formats for the Talk Group ID, but not all
formats are used by each system type. Choose the Talk Group ID format used by
this system:
Dec : The system uses a decimal (base 10) format for the Talk Group IDs
(available for all trunked systems)
Hex : The system uses a hexadecimal (base 16) format for the Talk Group
IDs (available for P25 and Motorola systems only)
AFS : The system uses the Agency-Fleet-Subfleet format for the Talk Group
IDs (available for EDACS wide or narrow systems only)