Filter
Top Products
UBCD396XT
121
Set Frequencies
Use this menu to program frequencies for this site.
Set Modulation
Select what type of modulation the scanner should use for this frequency or
channel. (Only the modulation types available for this frequency or channel are
displayed.)
Auto
The scanner uses the default modulation type for this frequency's band.
NFM
The scanner treats the frequency as a Narrowband FM band.
FM
The scanner treats the frequency as an FM band.
Set Attenuator
Turn on attenuation to reduce the signal strength by 20 dB. You can turn on
attenuation for individual frequencies and channels or for entire sites. If you turn
on attenuation for a site, all frequencies within that site will be attenuated.
Set Lockout
Decide whether you want to lock out the site so the scanner will ignore it during
Scan and Search modes. Choose one of the following options:
Unlocked: The site is not locked out.
Temporary L/O: The site is locked out until you turn the scanner off and
back on.
Lockout: The site is permanently locked out.
Set Hold Time
Set the minimum number of seconds the scanner should spend checking this
system or site even if there is no traffic on any channel. (The scanner always
checks each channel in a system or site once even if the hold time is set to 0
seconds.) Select the number of seconds from 0 through 255 (0 is the default).
Set LocationInfo
Use this menu to program location information for this site.