Filter
Top Products
To record a tour:
1. Click the Start Recording button. The system prompts you to overwrite the existing tour.
2. Click Yes to overwrite the existing tour movements.
3. Click the View Control link, under the image cameo, to access the directional and zoom
controls.
4. Use the View Control dialog box to make the necessary camera movements.
5. Click the Stop Recording button to save all actions.
Compass
The camera allows a user to display the compass heading of the camera in the lower-right
corner of the image display. The camera displays the cardinal or intercardinal (N, NE, E, SE, S,
SW, W, NW) heading in which the camera is pointing.
Notice!
The compass feature is not compatible with Bosch’s Intelligent Tracking feature. If Intelligent
Tracking is activated, the camera automatically disables the display of the compass heading.
Once Intelligent Tracking is deactivated, the camera returns the compass heading to the
display.
You must first calibrate the camera to North before the camera displays accurate compass
headings. The camera uses this calibration, usually set to magnetic North, as the zero degree
pan position and as the North compass heading. The camera then displays the compass
heading based on the number of degrees from the North calibration point.
To set the North calibration point:
1. Determine the North compass heading, then move the camera to that position.
2. Click the Set button next to “North point” to set the calibration point.
3. Click the On radio button for the Compass parameter.
Diagnostics
Accesses the Built-in Self Test (BIST). The BIST displays a Pass or Fail status on the most
recent homing event, not a counter. For the other items, a counter is maintained.
Click the Start BIST button to display the number of times the camera:
– performed a homing event.
– failed to home properly.
– restarted.
– lost video.
Prepositions and Tours
The camera can store up to 256 preset scenes. You can define the individual scenes that
comprise a preposition tour.
You define individual preposition scenes, then use these scenes to define the preposition tour.
The tour starts from the lowest scene number in the tour and progresses sequentially to the
highest scene number in the tour. The tour displays each scene for a specified dwell time
before advancing to the next scene.
By default, all scenes are part of the preposition tour unless removed.
To define and edit an individual scene:
1. Navigate to the scene that you want to define as a preposition.
Click the View Control link.
Use the PTZ controls to move the camera into position.
2. Click the Add scene (“+”) button to define the preposition.
3. Select a number for the scene, from 1 to 256.
14.18
14.19
106 en | Configuration via IP, Advanced Mode AutoDome 7000 Series (IP and HD)
2013.07 | 1.2.2 | F.01U.283.679 Operation Manual Bosch Security Systems