Filter
Top Products
4 Configure the settings on this page based on the addresses provided by your local
network administrator.
Notice!
Click the Help on this page? link if you need more information.
4 Click Set and Reboot. The camera will reset (go through the homing sequence, which
usually takes 30 seconds to complete), and then the LIVEPAGE appears, with updated
video and the new IP address.
NOTE: Screenshots of configuration settings in this manual are from an AUTODOME 7000 HD
model. Because of firmware or software updates, the screenshots may differ slightly from the
configuration settings screens in your system. Every effort has been made to ensure that the
information in this manual is accurate and current.
About the SETTINGS Page
The SETTINGS page provides access to the configuration menu, which contains all the unit's
parameters arranged in groups. You can view the current settings by opening one of the
configuration screens. You can change the settings by entering new values or by selecting a
predefined value from a list field.
There are two options for configuring the unit or checking the current settings:
– Basic mode
– Advanced mode
In Basic Mode, the most important parameters are arranged in seven groups. This allows you
to change the basic settings with just a few entries and then put the device into operation.
Figure 12.2: Basic Mode menu
Advanced Mode is recommended for expert users or system support personnel. You can
access all unit parameters in this mode. Settings that affect the fundamental functionality of
the unit (such as firmware updates) can only be altered in the advanced mode.
AutoDome 7000 Series (IP and HD) Configuration | en 81
Bosch Security Systems Operation Manual 2013.07 | 1.2.2 | F.01U.283.679