Filter
Top Products
Installing the VGA-PEND-WPLATE
This section provides instructions to install a wall, corner, or mast mount with the VGA-PEND-
WPLATE Mounting Plate instead of a Power Supply Box.
!
Caution!
You must route the main power supply through a 120/230 VAC transformer (VG4-PSU1 or
VG4-PSU2 power supply box) before connecting the power to a 24 VAC AUTODOME camera.
!
Warning!
A stud diameter of 6.4 mm (1/4 inch) to 8 mm (5/16 inch) able to withstand a 120 kg (265 lb)
pull-out force is recommended. The mounting material must be able to withstand this pull out
force. For example, 19-mm (3/4-inch) minimum for plywood.
1. For a Corner installation:
Secure the Corner Plate to the wall corner using four (4) studs (not included).
Secure the Mounting Plate to the Corner Plate using the four (4) 3/8 x 1-3/4-inch bolts
and split lock washers (supplied).
2. For a Mast or pole installation:
The metal straps included with the Mast mount accommodate a pole with a diameter of
100–380 mm (4–15 in.). You must use a banding tool (sold separately) for a mast or pole
installation. In addition, you must obtain a 3/4 in. (20-mm) right angle conduit connector
through which you route the wires that connect to the pendent arm.
Follow the instructions provided with the banding tool to securely mount the Mast Plate
to the pole. Contact your Bosch Sales Representative to order Banding Tool P/N
TC9311PM3T.
Secure the Mounting Plate to the Mast Plate using the four (4) 3/8 x 1-3/4-inch bolts and
split lock washers (supplied).
Remove one of the rubber gaskets from the Mounting Plate.
Once the Mounting Plate (item 1, below) is attached to the Mast Plate (item 2), connect
the right angle conduit (item 3) to the Mounting Plate through the empty conduit hole as
shown below:
7.6
AutoDome 7000 Series (IP and HD) Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en 33
Bosch Security Systems Operation Manual 2013.07 | 1.2.2 | F.01U.283.679