Filter
Top Products
14. Attach the 6-pin serial communication mating connector to the Serial Communications
cable (cable 8).
15. Connect the Earth ground wire, if available, to the crimp ring terminal inside the
Mounting Plate.
Note: The Earth ground is not provided with the VGA-PEND-WPLATE kit; it is a ground
connection made at the installed location.
16. After making the harness connections to the Mounting Plate, rotate the Pendant Arm to
close and tighten the two (2) captive screws to 10‑12 N-m (90-105 in.-lbs).
Notice!
After all wiring is complete, close the cover door and tighten the two (2) captive screws on
the cover door to 10-12 N-m (90-105 in.-lbs).
Attach Pendant to Arm and Tighten
Notice!
Before attaching the AUTODOME Pendant, visually inspect the dome and arm connectors for
any blocked pin holes or bent pins.
1. Tilt the bottom of the dome toward the pendant arm base and place the mounting hook,
located on top of the dome housing, over the recessed hinge pin of the arm.
7.7
AutoDome 7000 Series (IP and HD) Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en 37
Bosch Security Systems Operation Manual 2013.07 | 1.2.2 | F.01U.283.679