Filter
Top Products
Figure 10.2: Pendant Bubble Release Opening
3. Firmly rotate the bubble counterclockwise approximately 20 degrees until the bubble
assembly releases from the Pendant Housing.
Replace the trim ring (optional) (In-ceiling models)
The dome bubble for in-ceiling models of AUTODOME 7000 comes assembled with a white
trim ring. An optional black trim ring is supplied in the shipping box. To replace the white trim
ring, follow these steps:
1. Remove the four (4) Phillips head screws from the inner ring.
2. Remove the white trim ring.
3. For In-ceiling models, verify that the trim ring gasket is in place. (Refer to the graphic in
Installing the Ceiling (IP54 Housing) Gasket, page 63 for an illustration of the correct
placement of the gasket.)
4. Place the black trim ring over the inner ring.
5. Replace and tighten the four (4) screws.
68
en | Preparing the Bubble AutoDome 7000 Series (IP and HD)
2013.07 | 1.2.2 | F.01U.283.679 Operation Manual Bosch Security Systems