Filter
Top Products
1. Choose the desired location to mount the dome, and remove an adjacent ceiling tile.
2. Loosen the four (4) securing screws, located in the corners of the Bracket Assembly,
enough to hold the suspension bars but still allowing adjustment during installation.
3. Place the Bracket Assembly over the ceiling tile, which is used to mount the camera. Then
snap the Bar Clips of the bracket to the ceiling rails.
A
Figure 9.2: Suspension Ceiling Bracket (Top View)
1
Suspension Bars 3 Securing Screw (4)
2 Base Plate 4 Bar Clips
1. Use the bracket Base Plate as a template or cut a holesize hole in the center of the ceiling
tile with a drywall utility saw or jig saw.
Figure 9.3: Cut Hole in Ceiling Tile
2. Tighten the four (4) securing screws to the Bracket Assembly.
58
en | Installing the In-Ceiling Mount AutoDome 7000 Series (IP and HD)
2013.07 | 1.2.2 | F.01U.283.679 Operation Manual Bosch Security Systems