Filter
Top Products
!
Caution!
Save each change with the associated Set button.
Clicking the Set button saves the settings only in the current field. Changes in any other fields
are ignored.
Pre-programmed User Modes
Five (5) pre-programmed but configurable user modes, optimized with the best settings for a
variety of typical applications, make camera programming on-site easy and user-friendly. Users
select from the menu the mode that best defines the environment in which the camera is
installed:
– Outdoor – general day-to-night changes with sun highlights and street lighting
– Indoor – general day-to-night changes without sun highlights and street lighting
– Lowlight – enhanced display of scene in low light
– Motion – monitoring traffic or fast moving objects; motion artifacts are minimized
– Vibrant – enhanced contrast color reproduction and sharpness
Users have the ability to customize these modes, if necessary, for the specific requirements of
the site.
Configuring Audio (Optional)
Enabling Audio Transmission
To transmit audio via the IP connection, follow these steps:
1. Open the AUTODOME 7000 Series LIVEPAGE, then click the Settings tab.
2. In the left pane, click Advanced, and then click Web Interface. The Web Interface menu
expands.
3. Click LIVEPAGE Functions. The LIVEPAGE Functions page appears.
4. Click the Transmit Audio radio button to enable for audio.
Activating Audio Reception
To configure audio via the Web browser, follow these steps:
1. Open the AUTODOME 7000 Series LIVEPAGE, then click the Settings tab.
2. In the left pane, click Advanced Mode, and then click Camera. The Camera menu
expands.
3. Click Audio. The Audio page appears. The page displays the current video image in the
small window next to the slide controls to help you verify the audio source and improve
the Peak levels.
4. Select the protocol in the Audio field to activate audio over IP. (Change the option to
ON.)
Notice!
The audio signal is sent in a separate data stream parallel to the video data, and so increases
the network load. The audio data is encoded according to G.711 or L16 and requires an
additional bandwidth of approximately 80 Kbit/s for each connection.
5. If you wish to configure the input and output gain of the audio signals, set the Line In and
Line Out fields to suit your specific requirements. Changes are effective immediately. The
current level is displayed next to the slide control to help do this. Make sure that the
display does not go beyond the green zone during modulation.
For more information, refer to Audio, page 108.
12.3
AutoDome 7000 Series (IP and HD) Configuration | en 83
Bosch Security Systems Operation Manual 2013.07 | 1.2.2 | F.01U.283.679