Filter
Top Products
113
Storing the Camera Settings
Chapter 5 VISCA Camera Operations
To set the camera moving speed to the preset position
You can select the panning/tilting speed at which the camera moves to the preset
position.
You can preset the moving speed of the camera in position numbers 1 to 6 for
the BRC-300/300P and in position numbers 1 to 16 for other models.
1
Follow the steps in “To recall the preset camera setting” (page 112) to recall
the camera setting stored in the camera position.
The selected position number is displayed at the lower left of the display
panel.
2
Hold the PST SPD button pressed to light up the button.
The CAMERA 1 to 7 buttons can be used for setting the speed. The button
that corresponds to the currently selected speed lights up. Other CAMERA
buttons flash.
3
Press one of the CAMERA 1 to 7 buttons to set the panning/tilting speed
while the button is flashing.
The panning/tilting speed to be set increases in the order of CAMERA 1 to
7. You can set seven panning/tilting speeds stored for CAMERA button 1
(the lowest speed: 1 degree/sec.) to CAMERA button 7 (highest speed: 60
degrees/sec.)
Press the CAMERA button within five seconds after the PST SPD button is
pressed. After five seconds the CAMERA buttons stop flashing, and speed
setting mode is canceled. In this case, repeat steps 2 and 3 again.
Note
Note
CAM
CAMERA
DSK
LOW HIGH PRESET
S
P/T RST
PIP
PST SPD
AUX 1
AUTO/MANUAL
AUX 2
O P AF
CAMERA
DSK/AUX
SW
123456789
PST SPD button