Filter
Top Products
98
Storing the Settings of a Wipe, PIP, and Setting Menu Items
Chapter 4 Switching Operation
If “DIRECT” is not displayed, press the F3 control to display it.
4
Turn the F3 control to display “SS” (snapshot), “Wipe,” or “PIP” under
“DIRECT” according to the setting you wish to store.
“SNAP:,” “WIPE:,” or “PIP:” is displayed at the bottom left of the display
panel.
Example of a wipe:
5
Check that the DIRECT RECALL button is not lit.
If the DIRECT RECALL button is lit, press the button to make it go dark.
6
Press numeric buttons 0 to 9 to enter a register number.
To store in a snapshot register, enter a snapshot number between 0 and 99.
To store a wipe pattern or the settings of PIP video, enter a direct wipe
number 0 to 9 or a direct PIP number 0 to 9.
The selected number appears and flashes next to “SNAP:,” “WIPE:,” or
“PIP:” at the bottom left of the display panel.
7
Hold the PRESET button pressed.
The indication “Storing Preset Data.” appears at the bottom left of the
display panel, and the setting is stored.
To recall the registered settings
1
Check that the SW mode button is lit.
If the SW mode button is not lit, press to light up the button to set the
switcher to SW mode.
2
Check that “DIRECT” is displayed on the display panel above the F3
control.
If “DIRECT” is not displayed, press the F3 control to display it.
3
Turn the F3 control to display “SS,” “Wipe,” or “PIP” under “DIRECT”
according to the setting you wish to recall.
“SNAP:,” “WIPE:,” or “PIP:” is displayed at the bottom left of the display
panel.
4
Check that the DIRECT RECALL button is not lit.
If the DIRECT RECALL button is lit, press the button to make it go dark.
5
Press numeric buttons 0 to 9 to enter the register number in which the setting
you wish to recall is stored.
SW MODE MV TYPE XPT HOLD DIRECT ME AUTO
WIPE: 4 Off Wipe 30
SW MODE MV TYPE XPT HOLD DIRECT ME AUTO
WIPE: 1 4 Off Wipe 30
Flashing